Posted on March 6, 2021July 13, 2021 by Rob L. — 2 CommentsMost important To view this content, you must be a member of ROBERT's Patreon at $1 or more Unlock with PatreonAlready a qualifying Patreon member? Refresh to access this content. Post navigationPrevious post: Raspi /arduino cam caseNext post: Web site is up content will be loaded soon and important message for klipper 2 thoughts on “Most important” Dave Fishpig September 9, 2021 G’day Mate, I managed to setup a standalone and uploaded as you described but everytime i go to print i get “Reported error: Invalid gpio port 25” and on the duetweb page it says gpio 24, 25 and 26. Reply Rob L. September 10, 2021 hey how are you . you need to change the lights to pin 1 2 and 3 at the end of your start code Reply Leave a Reply Cancel replyYour email address will not be published. Required fields are marked *Comment * Name * Email * Website Save my name, email, and website in this browser for the next time I comment.