Posted on 5 Comments

RRF3 Upgrade Troodon

1.     First upload the .g files for your printer but delete the 300 or 400 off the back and do not restart.

 2.    Then upload DuetWebControl-SD-2.1.6.zip while inside the System tab, also upload the following bin files from the sys directory, one at a time, in order. Don’t install and restart when prompted for these but upload all then go back and upload again clicking install the second time around . Duet2CombinedIAP.bin, DuetWiFiServer-1.23.bin, Duet2CombinedFirmware_3.0.0.bin . Should be good but if any problems go to console on printer and enter m997 s0:1 

Notes 

Baud rate must be set to 57600 on the panel please do before starting but if you forget and it isn’t connecting you can change after. I updated instructions to just manually install from printer screen encase files get installed in wrong order this adds few steps but makes It less likely to lose wifi saved settings during upgrade. 

*****These configs are for dd extruder if you want to use stock you need to change back to 1200 mah for the extruder driver and also stock timings which are B2 Y4:4 F4 and you do not need to use the bed.g files I just like the double tram I set up. Also make sure to adjust to your probe offset unless you have it saved in your config override. You also will need to revert to original steps which should be around 413 iirc.

******anyone wanting help just send me a zip with their sdcard minus the gcode folder and i will setup everything so that you can just upload the files i send back and not have to worry about anything or can manually take sd card out and copy the files back ont o sd card put back in printer and run a macro from screen i setup for you.

5 thoughts on “RRF3 Upgrade Troodon

  1. G’day Mate,

    Hey i have the troodon 400 at work and i run it through USB to Octoprint with the wifi disabled due to security reasons, do i just put all the files on the SDcard and put it in the printer?
    I’m new to reprap style.
    Cheers man

    1. You can use the sd card or i would maybe think of getting an ehternet cable to use with the rpi which could make it real easy to upload files . Last is what if you made a standalonme wifi network for the printer . So the printer makes its own adhoc network you connect. You can also use a usb flash drive.

    2. you can pm me on facebook join the troodon advanced group and you will know who i am on it.

  2. Hello, I am looking for the original or best firmware for troodon 400. My gantries do not auto adjust. I just get regular mess adjustment but the gantry is off

    1. I emailed and i will add the conclusion the post to help others

Leave a Reply to Dave Cancel reply

Your email address will not be published. Required fields are marked *